My only remaining concerns are pressing the new ones in and refilling the.
Aug 11, If your rear axle is making a clunking noise while driving over bumps in the road, then your rear bushings might need replaced. In this video, I show how to. Aug 20, On the right side I removed the bushing bracket with the axle.
By 8 the axle was rolled out from under the car. I had purchased a 2 inch, 3/4 drive socket specifically for the bushing removal as the socket's outer diameter was just a shade under the mm of the bushing OD. Jan 30, jack the jack up a touch and take a bit of the weight of the subframe remove all 4 bolts and axle will stay where it is, lower jack down ul know when its enough as hard pruning native trees jack will stop touching the axle, the axle wont go any where, jack back up the jack and just touch the axle.
jack up the rear axle and the bracket will go roughly to where it. Aug 29, VW golf tdi Feb 28, #3 as far as the job itself can be done in a day.
Mine were TT bushings, and were dry rotted but not shot.
I prefer to remove the axle. Once out, about 30 min to R&R the bushings. I just read about another person with two Golfs that changed those rear axle bushings and got no relief from the clunking or an improvement in ride either.
Finally available at IDParts, this rear axle bushing tool makes pressing in new rear axle bushings a breeze.
Timing Solenoid Valve.
Works on all MkIV Golf, Jetta and New Beetle. Uses two large, fitted plates to squeeze the bushing into the axle without needing to remove the axle or use a press! Plates are squeezed together by a threaded rod (similar to a rear brake tool). BMW E87/90/93 M3 Rear Lower Control Arm Bushing Ball Joint Remover and Installer. Rear Axle Bushing Remover Installer Removal Tool BMW. Manufacturers #: BMATransmission Bushing Repair Tool for Mercedes, BMW, Ford.
Manufacturers #: MBAVW MKIV Golf Jetta Rear Axle Bushing Tool. Manufacturers #: VWA