It's like a totally different machine.
You must log in or register to reply here.
Sep 06, One thing I do when putting these pins back in; remove ALL grease from the pin and Bobtach bushing, apply a coating of spherical Loctite to the tapered part of the pin, insert pin in Bobtach, slide it up in place then (with a longer bolt threaded in finger tight) pull the pin into place, remove that bolt and apply Loctite to the retaining bolt and torque it down.
Jun 02, If it wasn't for the bushing removal problem I'm guessing it took 3 or 4 hours to clean up the holes, take measurements and machine the tapered bushings. Edit: I just looked at the parts diagram I got from Bobcat and still don't see any weld in bushings on the Bobtach ears.
Jan 25, Re: How to remove Bob-Tach in reply to David in SC, The pin that the bolt threads into is tapered where it goes into the lift arm, and if it is not tight it will allow the pin and bolt combo to turn, probably need an air impact wrench. Jul 14, Heat expands metal, the expansion is constrained by the bore causing the bushing's thickness to increase and as it cools, decreasing the OD of the bushing.
I use that method to remove all bearing races and bushings where it will work.
It's quick and easy. lumberjack, Jun 26, Remove the bushings from the tilt piston rod ends. Install the new bushings in the rod ends using a hammer and bushing driver. These bushings do not have grease seals and will extend to both sides of the rod end.
Step 9Missing: bobtach. Dec 27, I went to the dealer this morning and bought new pins, bushing and the updated dust seal and cap. dollars later I left with all the crap to fix it. I couldn't find any information on the net that really showed how the pins come out, from the outside it looks a bit confusing how it comes apart but once you get the pin losened from the.
in-1 Custom Bushing Driver Tool Set, Transmission Wheel Axle Bearing Race Seal Installer Remover, Bush Removal Puller Bearing Press Tool Kit with Storage Case. out of 5 stars. Missing: bobtach.